At a Store

In order to buy the correct vent repair device, you must determine what size vent shield you need.  You may do this by measuring the diameter of your vent at the exit. If it’s 3 inches or under including flashing, then you need a Small (S) Vent Repair Flashing. If its 4 inches in diameter including flashing you need a Large(L) Vent Repair Flashing. You may notice that the lead flashing is very rough (not round) and beat up on top, this is because it is a sheet of lead that is folded over the pipe and some home builders are less careful than others. However, this lead flashing layer is very soft and can be tapped with any small hammer, wrench, screwdriver, or by hand into a round shape that will fit under your new Critter Quitter®. Below the store locations is a video which shows how to measure the vents.

Unless indicated otherwise, the following retailers carry Critter Quitters® for purchase. If you need more help, Call 1-866-290-5334 or visit www.AceHardware.com.

 

Florida

Groveland

Groveland Ace Hardware
1007 Hwy 50

Tel#: 352-429-7616

Maitland

Maitland Ace Hardware
1607 S Orlando Ave

Tel#: 407-645-3366

Orlando

Avalon Ace Hardware
14807 E Colonial Dr, Unit 136

Tel#: 407-382-2007

 

Colonial Ace Hardware
2523 E Colonial Dr

Tel#: 407-895-7003

 

Conway Ace Hardware
4434 Curry Ford Rd

Tel#: 407-482-5085

 

Orlando Ace
2218 S Orange Ave

Tel#: 407-422-7766

 

South Orange Ace Hardware
9689 S Orange Blossom Trl

Tel#: 407-859-1142

Winter Garden

Bray Hardware Company Inc
500 S Dillard St

Tel#: 407-656-2593

 

Determining Diameter

 

Homes built prior to 1960 often had large cast iron 4 inch vents. These will have a 5 3/8 inch diameter flashing. If you have one of these, or a newer home with the oddball 4 inch vent, we can supply you one of our Extra Large (XL) shields. Call us at 407-808-2501 for more information on how to order.

Comments are closed